Example - CipherLab 1564 User Manual

1564 Barcode Scanner

EXAMPLE

Without using the scanner to read the above setup barcodes for configuring the 3656
stand, you may run HyperTerminal.exe on the host computer to send serial commands to
3656 via RS-232 or USB.
1) Connect the interface cable, RS-232 or USB, between 3656 and your computer.
2) Connect the power supply cord from 3656 to a proper power outlet.
The Communication LED will indicate when 3656 can accept serial commands after
initializing. Refer to the table below.
If the output interface is USB Virtual COM or RS-232, run HyperTerminal.exe on
your computer. While the Communication LED on 3656 is purple (red with flashing
blue), type the serial command within three seconds.
If the output interface is USB HID, press the "Num Lock" or "Caps Lock" key on
your keyboard 5 times within 3 seconds while the Communication LED on 3656 is
flashing red and blue. This will change the interface from USB HID to USB Virtual
COM and the Communication LED will become purple (red with flashing blue).
Then, run HyperTerminal.exe on your computer. While the Communication LED on
3656 is purple (red with flashing blue), type the serial command within three
seconds. After configuring via serial commands, the interface will be reset to USB
HID after re-connecting the power supply cord.
Communication LED
--- Blue,
solid
Red, Blue,
solid flashing
Red, Blue,
flashing flashing
246
User Guide
Meaning
Initialize
Serial command mode with USB Virtual COM or RS-232: wait 3 seconds for
starting a serial command
Serial command mode with USB HID changed to USB Virtual COM first: wait
3 seconds for pressing [Num Lock] or [Caps Lock] 5 times via keyboard
Enter Setup