Ani Number; Dnis Number - Nortel Modular ICS 6.0 Installer's Manual

Nortel modular ics 6.0 digital system package

Hide thumbs Also See for Modular ICS 6.0:

Table of Contents

ANI Number

Select whether the telephone number of the caller will be

collected for this line. The digits can then be displayed on

Norstar telephones as part of Call Display services.

Press CHANGE to select either: N (No) or Y (Yes).

mode.The delivery of ANI/DNIS depends on the network

provider and the services they offer. This setting applies only

to E&M and DID lines.

For E&M or DID lines connected to a DTI, the setting only

appears if Signal is WinkStart. For lines connected to an E&M

or DID Trunk Cartridge, the setting only appears if Signal is

WinkStart or Immediate.

If the conditions for signalling mode and start arrangement

are not met, prompts are not presented to the user. No

additional equipment is required.

Select whether the digits dialed by an external caller on this

line will be collected.

Press CHANGE to select either: N (No) or Y (Yes).

For E&M lines connected to a DTI, this setting only appears

if Signal is WinkStart and Ans mode is Manual. For E&M lines

connected to an E&M Trunk Cartridge, this setting only

appears if Signal is WinkStart or Immediate and Ans mode is

These digits are required for some third-party software

applications.

Modular ICS 6.0 Installer Guide

The central office must deliver ANI/DNIS in DTMF

This setting applies to E&M lines only.

Installer password required

Do you have a question about the Modular ICS 6.0 and is the answer not in the manual?