268 / Installing ISDN BRI terminal equipment
Installing ISDN BRI terminal
equipment
For each S or T or U-LT reference point, an eight-position
miniature unkeyed plug from the terminal equipment (TE) is
plugged into a jack connected to Norstar wiring. The pin
connections for the jack and plug are shown in the following
charts.
S or T wiring for terminal equipment
Pin
(jack or plug)
1
2
3
4
5
6
7
8
S or T extension wiring configurations
The last connection on any ISDN S or T extension wiring must
have terminating resistors to ensure correct timing of the
signaling circuits. Failure to install terminating resistors will
degrade performance. Terminating resistors should not be
connected on a TE which is not the last connection on the loop.
Terminating resistors are provided on terminal equipment. See
the instructions that come with your TE for information on
how to enable or disable the termination, as required.
Modular ICS 6.0 Installer Guide
Norstar connection
(for jack)
not used
not used
+Rx
+Tx
-Tx
-Rx
not used
not used
Equipment connection (plug)
optional power source 3 (+)
optional power source 3 (-)
+Rx
+Tx
-Tx
-Rx
optional power sink 2 (-)
optional power sink 2 (+)
P0992638 03