ADT Unimode 400 Multi-Net Installation Manual page 190

$SSHQGL[ ( 7HUPLQDO ,QWHUIDFH 3URWRFRO
/RFDO 0RQLWRU 0RGH
/RF0
E-2
Table E-1 summarizes the functions available with the Local Terminal mode:
Function Lets you...
Read Status • Display the status of an individual point (Detector, Module, Panel Circuit,
or Zone).
• Display a list of all the points in Alarm or trouble.
• Display a list of all programmed points in the system.
• Step through the history buffer event by event.
• Display the entire history buffer.
Alter Status • Disable/Enable an individual point.
• Change the sensitivity of a detector.
• Clear the verification counter of all detectors.
• Clear the entire history buffer.
• Set the AWACS alert and action levels.
Control Functions • Acknowledge.
• Alarm Silence.
• System Reset.
• Alarm Activate.
Functions, passwords, and special requirements of Local Monitor Mode (LocM) are:
Functions: Read Status, Alter Status, and Control Functions (Table E-2).
User-defined password for Alter Status and Control functions.
Passwords:
Requirements: Password security feature for Control Functions eliminates the
need for mounting the CRT-2 in an enclosure.
Table E-3 summarizes the functions available with the Local Monitor mode:
Function Lets you...
Read Status • Display the status of an individual point (Detector, Module, Panel Circuit,
or Zone).
• Display a list of all the points in Alarm or trouble.
• Display a list of all programmed points in the system.
• Step through the history buffer event by event.
• Display the entire history buffer.
Alter Status • Disable/Enable an individual point.
• Change the sensitivity of a detector.
• Clear the verification counter of all detectors.
• Clear the entire history buffer.
• Set the AWACS alert and action levels.
Control Functions • Acknowledge
• Alarm Silence
• System Reset
• Alarm Activate
7DEOH ( /RF7 )XQFWLRQV
7DEOH ( /RF0 )XQFWLRQV
Unimode 400 Installation PN 50710:A 10/22/97
Operating Modes