Connecting The Interface Cable To The Printer; Parallel Interface Cable - Star TSP700II SERIES Hardware Manual

3-2. Connecting the Interface Cable to the Printer

Printer cables are not included in the package.
Obtain an appropriate cable that complies with the specifications beforehand.
Because the appropriate interface cable differs depending on the system that you are connecting the printer to, contact
the dealer that you bought the product from if you are unsure about what cable to use.
Before connecting or disconnecting an interface cable, be sure to disconnect the AC adapter's power cord
from the outlet.

3-2-1. Parallel Interface Cable

To connect a parallel cable, follow the procedure given below.
(1) Make sure the printer is turn off.
(2) Affix the ferrite core onto the cable as shown in the illustration.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it. Use scissors to cut
off any excess.
(5) Connect the interface cable to the connector on the rear panel of
the printer.
(6) Fasten the connector clasps.
Fastener
- 4 -
Ferrite core
Interface cable
5 cm
(maximum)
Pull and cut
Parallel interface cable