Connecting The Cable To The Printer - Star SP742R Series Hardware Manual

4-2. Connecting the Cable to the Printer

Note that the interface cable is not provided. Please use a cable that meets specifications.
CAUTION
Before connecting/disconnecting the interface cable, make sure that power to the printer and all the
devices connected to the printer is turned off. Also make sure the power cable plug is disconnected
from the AC outlet.
4-2-1. Parallel Interface Cable
(1) Make sure the printer is turn off.
(2) Affix the ferrite core onto the cable as shown in the illustration.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it. Use scissors to cut
off any excess.
Ferrite core
Interface cable
(5) Connect the interface cable to the connector on the rear panel of
the printer.
(6) Fasten the connector clasps.
10 cm
(maximum)
Fastener
– 7 –