Usb Cable - Star TSP700II SERIES Hardware Manual

3-2-2. RS-232C Interface Cable
(1) Make sure that the AC adapter's power cord is not connected to the outlet.
(2) Connect the interface cable to the connector on the rear panel of the printer.
(3) Tighten the connector screws.

3-2-3. USB Cable

To connect a USB cable, follow the procedure given below.
(1) Make sure that the AC adapter's power cord is not connected to the outlet.
(2) Connect the USB cable to the USB port.
(3) As shown in the figure, pass the cable through the cable hooks to hold it in place.
4 cm (maximum)
RS-232C interface cable
Cable hook
USB cable
- 5 -