Star TSP700II SERIES Hardware Manual page 15

3-6-1. Compliant Paper Roll Specifications
Paper thickness
Paper width
External dimensions
• Roll diameter
• Take up paper roll width
Printed surface
Note 1: Do not glue or tape the paper roll and shaft core together.
2: Do not fold the tail end of the paper.
3: For details on recommended thermal paper, see the following webpage.
http://www.starmicronics.com/support/
3-6-2. Removing the Tension Bar
When using thermal paper roll, the tension bar unit may or may not be necessary, depending on the paper thickness,
paper width, or the installation layout. If the tension bar unit is unnecessary, remove it in accordance with the procedure
indicated below. The tension bar unit is unnecessary when using full-face thermal label paper roll or thermal label paper
roll (tack label paper).
Installation layout
Paper width (mm)
Paper thickness
between 65 μm and 100 μm
Paper thickness
between 100 μm and 150 μm
Horizontal
Use a flat head screwdriver as shown to remove the clips at both
ends of the tension bar. Then, remove the tension bar unit.
65 to 75 μm: f 18±1mm(Core outer), f 18±1mm(Core outer)
65 to 75 μm: f 32±1mm(Core outer), f 25.4±1mm(Core outer)
Thermal Paper
75 to 150 μm: f 32±1mm(Core outer), f 25.4±1mm(Core outer)
Thermal Label Paper Max.150 μm
79.5 ± 0.5 mm or 82.5 ± 0.5 mm or 57.5 ± 0.5 mm
Thermal Paper
79.5 ± 0.5 mm or 82.5 ± 0.5 mm
Thermal Label Paper
Max. f 100 mm
80
Outer edge of roll
Horizontal
82.5
Necessary Necessary
Un-
necessary necessary
+0.5 +0.5
mm / 83 mm / 58
- 1 - 1 - 1
79.5 57.5
Necessary
Un- Un-
necessary
Vertical
- 11 -
+0.5
mm
Vertical/wall-mount
82.5 79.5
Necessary Necessary
Un- Un-
necessary necessary
Wall-mount
57.5
Un-
necessary
Un-
necessary