Turning The Power On; Connecting To A Peripheral Device - Star TSP700II SERIES Hardware Manual

3-4. Turning the Power On

Connect the power cord according to the procedure in section 3-3, "Connecting the AC Adapter".
Turn on the power switch, which is on the front side of the printer.
The POWER lamp on the control panel will light.
Power switch

3-5. Connecting to a Peripheral Device

You can connect a peripheral device to the printer using a modular plug.
Follow the procedure given below.
(1) Make sure that the AC adapter's power cord is not connected to the outlet.
(2) Connect the modular jack plug to the peripheral drive connector on the rear panel of the printer.
Connect the other end of the cable to the modular jack of the peripheral device.
CAUTION: Do not connect a telephone line to the peripheral drive connector. Doing so may cause the printer
to malfunction. Also, for safety purposes, do not connect a wire that may carry excessive voltage to
the peripheral drive connector.
- 8 -