Ethernet Cable - Star TSP700II SERIES Hardware Manual

3-2-4. Ethernet Cable

If a ferrite core is included, install the ferrite core onto the Ethernet cable according to the following procedure to
prevent electrical noise.
If a ferrite core is not included, perform steps (1) and (5) only.
When using an Ethernet cable that is 10 cm or less, shielded cable is recommended.
(1) Make sure the printer is turned off.
(2) Install the ferrite core onto the ethernet cable as shown in the illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it. Use scissors to cut off any excess.
Ethernet cable
Ferrite core
(5) Connect the interface cable to the connector on the rear panel of the printer.
Link disconnection detection feature
g
The Ethernet interface model is equipped with a link disconnection detection feature.
If the printer is turned on when an Ethernet cable is not connected to it, the POWER and ERROR lamps are simul-
taneously turned on and off at 4-second intervals to indicate the disconnection.
Be sure to connect the Ethernet cable from a PC or hub to the printer, and then turn the printer on.
10 cm
(maximum)
Fastener
Ethernet cable
IFBD-HE05
- 6 -
Ethernet cable
IFBD-HE07