Table of Contents
Advertisement
1-1. Unpacking
After unpacking the unit, check that all the necessary accessories are included in the package.
Paper roll
* Accessories vary depending on the model and the region where the printer was purchased.
1-2. Notes about Installation
1. Choose a firm, level surface where the printer will not be exposed to vibration.
2. Make sure that the printer is connected to a reliable power outlet. It should not be on the same electric circuit as copi-
ers, refrigerators, or other appliances that cause power spikes.
3. The power outlet you plan to connect to for power should be nearby and unobstructed.
4. Make sure that the printer is not exposed to direct sunlight.
5. Make sure that the printer is well away from heaters and other sources of extreme heat.
6. Do not locate the printer in a badly ventilated or dusty environment.
7. Make sure that the room where you are using the printer is not too humid.
8. This device employs a DC motor and switches that have an electrical contact point.
Avoid using the device in environments where silicon gas can become volatile.
9. Use the printer within the boundaries indicated in the environmental requirements. Even when the ambient tem-
perature and humidity are within the specifications, avoid radical changes in environmental conditions. The suitable
operating temperature range is as follows:
Operating temperature: 5°C to 45°C
10. When disposing of the printer, obey local regulations.
1. Unpacking and Installation
Printer
Switch blind
Note: The ferrite core and fastener provided with your printer depend on your
printer configuration.
Cable cover
Holding plate
Setup sheets
- 1 -
Screws
Roll stoppers
Shaft
CD-ROM
Hide quick links:
Advertisement
Table of Contents
