Attaching The Accessories; Attaching The Holder Plate - Star TSP700II SERIES Hardware Manual

The following accessories are necessary when mounting the printer to a wall.
• Holder plate and two flangeless screws
The following accessories do not necessarily have to be attached. Attach it if necessary.
• Cable cover
• Switch cover

4-1. Attaching the Holder Plate

<Precoutions>
n The holder plate is attached to the printer using the included screws and is hooked onto screws that are installed
into the wall.
n The screws on the wall are not included.
Use commercially available screws (4 mm diameter) that are suitable for the wall material (wood, steel beam,
concrete, etc.).
n The printer's weight is approximately 2.4 kg when the largest diameter roll paper is loaded.
Use screws on the wall that have both shear strength and pulling-out strength to withstand a force of at least
12 kgf (118 N).
(1) Attach the shaft to the printer.
Push in the left and right
ends of the shaft.
(2) Wipe the area into which the rubber feet will be affixed in order to remove any grime; then, affix the roll stoppers.
The positions for affixing them will vary depending on the paper width.
82.5 or 79.5 mm width

4. Attaching the Accessories

Shaft
57.5 mm width
- 20 -