Attaching The Accessories; Attaching The Holder Plate - Star TSP700II series Hardware Manual

4. Attaching the Accessories

The following accessories do not necessarily have to be attached.
Attach them if necessary.
• Holding plate
• Cable cover
• Switch blind

4-1. Attaching the Holder Plate

(1) Attach the shaft to the printer.
(2) Wipe the area into which the rubber feet will be affixed in order to remove any grime; then,
affix the roll stoppers. The positions for affixing them will vary depending on the paper
width.
(3) Use a regular screwdriver to remove the clips at
both ends of the bar to remove the tension bar
unit.
Push in the left and
right ends of the shaft.
82.5 or 79.5 mm width 57.5 mm width
– 17 –
Shaft