Please hold the microphone approximately 2.5-5.0cm from your lips
then speak into the microphone in your normal speaking voice.
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.
Transmitting Tone BURST TONE
Press and hold [PTT] key, then press Microphone
current selected tone-burst tone. Pre-programming is necessary.
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone
transmit pre-stored and selected DTMF/2Tone/5Tone optional signaling.
Preprogramming is necessary.
MEMORY CHANNEL PROGRAMMING
, and
1.
Under frequency mode (VFO), turn
Dial to select the desired frequency or
input frequency by MIC's numeric keys.
2.
Press
signaling setup, turn Main Dial to select
key to transmit
the desired signaling. See P.13 for details.
3.
Press
and current channel number,
is empty.
key to
4.
Turn
5.
Press
sounds twice.
6.
Press
stored.
MEMORY CHANNEL DELETING
1.
Under Memory mode, turn
deleted.
2.
Press
deleted beep sounds.
deleted.
Basic Operations
key to enter CTCSS/DCS
key, LCD appears
,
icon flashing means current channel
Main Dial to select the desired channel number to store.
key,
,
icon and channel number disappears and beep
V/M key again to confirm that the memory channel is properly
Main Dial to select channel to be
key and
key together, current memory will be
icon flashing means current memory is
5
Main
icon
12