LCD displays
icon, it indicates CTCSS encode set in current
channel.
LCD displays
and
decode set in current channel.
LCD displays DCS icon, it indicates DCS encode and decode set
in current channel.
3.
In corresponding icon, press [
CTCSS/DCS encode and decode.
4.
Press
,
, or
to confirm and exit.
Talk Around
By Talk Around function, you can directly communicate with other radios
in your group in case the repeater is not activated or when you are out of
the repeater range. The transceiver will transmit by RX frequency with its
CTCSS/DCS signaling.
1.
In standby, press
, then press
OF".
2.
Press [
/
] to select the desired setting .
ON:Enable Talk Around
OFF:Disable Talk Around
3.
Press number key to confirm and exit.
BEEP sound
The prompting tone provides confirmation of entry, error status or
malfunctions of the transceiver. You can enable or disable this function.
1.
In standby, press
, then press
2.
Press [
/
] to turn on/off BEEP prompt.
BEEP—OF: turn off the beep;
BEEP—ON: turn on the beep.
icon, it indicates CTCSS encode and
/
] to select the desired
key, LCD displays "TALK--
, LCD displays "BEEP--xx".
Microphone Operation
3.
Press number key to confirm and exit.
HIGH/MID/LOW Power Selection
1.
In standby, press
, then press
2.
Press [
/
] to select the desired power.
HI:High Power
MI:Middle Power
LOW:Low Power
3.
Press number key to confirm and exit.
LCD Backlight
1.
In standby status, press
"LAMP-xx" .
2.
Press [
/
] to select desired backlight brightness(1-32
levels).
3.
Press number key to confirm and exit.
9
, LCD displays "POW-xx".
, then press
LCD displays
26