Transmitting Tone Burst Tone; Transmitting Optional Signaling; Memory Channel Programming; Memory Channel Function List - Alinco DR-CS25 Instruction Manual

Speaking too loud distorts, too undertone won't modulate enough your
voice.
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.

Transmitting Tone BURST TONE

Press and hold [PTT] key, then press Microphone
selected tone-burst tone. Pre-programming is necessary.

Transmitting OPTIONAL SIGNALING

Press and hold [PTT] key, then press Microphone
transmit pre-stored and selected DTMF/2Tone/5Tone optional signaling.
Preprogramming is necessary.

MEMORY CHANNEL PROGRAMMING

1.
Be sure the undesired functions are turned off before programming.
Memory channels hold setting like signaling and power settings.
2.
If you wish to include settings such as signaling and power in the
memory, Set them to the VFO in advance to the memory programming
operation. Refer to the list on the right for parameters you may include in
a memory channel.
3.
Press key, LCD appears
FUNC
current channel appear on LCD. Flashing
means the current channel is empty.
4.
Press or Key to select the
desired channel number to store.
5. Press key, , icon and channel
number disappears and beep sounds twice.
6.
Press key again to confirm that the memory channel is properly
stored.
key to transmit
key to
, and
Basic Operations

Memory Channel Function List

Band Width
●
TX Power
●
CTCSS/DCS Encode / Decode
●
Optional Signal
●
TX Off
●
Scan Skip
●
Reverse / Talk Around
●
Busy Channel Lock-Out
●
In memory mode, the setting may be changed temporary but changing
a channel or turning off the radio will cancel the operation and returns to
programmed setting.

MEMORY CHANNEL DELETING

1. Under Memory mode, input by MIC's numeric keys to select
channel to be deleted. For example, choosing CH1, press [0] [0] [1].
2. Press key, LCD appears
FUNC
memory will be deleted and a beep sounds twice.
means current memory channel is deleted. Can not delete all
memory channels, at least one channel will be saved.
4
icon, then press key, current
P2
icon flashing
11