Speaking too loud distorts, too undertone won't modulate enough your
voice.
While transmitting, LED lights RED and TX-meter shows relative power level.
Release PTT to receive.
Transmitting Tone BURST TONE
Press and hold [PTT] key, then press Microphone
selected tone-burst tone. Pre-programming is necessary.
Transmitting OPTIONAL SIGNALING
Press and hold [PTT] key, then press Microphone
transmit pre-stored and selected DTMF/2Tone/5Tone optional signaling.
Preprogramming is necessary.
MEMORY CHANNEL PROGRAMMING
1.
In frequency mode (VFO), select the desired frequency.
2.
Press
key to enter CTCSS/DCS signaling setup, press microphone
P3
or
key to select the desired signaling in case you need.
See next page for more details.
3.
Press
key, LCD appears
FUNC
current channel appear on LCD. Flashing
means the current channel is empty.
4.
Press
or
Key to select the
desired channel number to store.
5.
Press
key,
,
icon and channel
number disappears and beep sounds twice.
6.
Press
key again to confirm that the memory channel is properly
stored.
key to transmit
key to
,
and
Basic Operations
MEMORY CHANNEL DELETING
1.
Under Memory mode, input by MIC's numeric keys to select
channel to be deleted. For example, choosing CH1, press [0] [0] [1].
2.
Press
key, LCD appears
FUNC
memory will be deleted and a beep sounds twice.
means current memory channel is deleted. Can not delete all
memory channels, at least one channel will be saved.
4
icon, then press
key, current
P2
icon flashing
11