Checking The Status Of Unified Communications Services; Additional Configuration - Cisco TelePresence Administrator's Manual

Unified Communications
Authentication
policy
Location section
Peer 1 address
Peer 2...6 address
Note that you should enable Unified Communications services on one traversal zone only per VCS.
4. Click Create zone.

Checking the status of Unified Communications services

You can check the status of the unified communications services on both VCS Control and VCS
Expressway.
1. Go to Status > Unified
2. Review the list and status of domains, zones and (VCS Control only) Unified CM and IM&P servers.
Any configuration errors will be listed along with links to the relevant configuration page from where you
can address the issue.

Additional configuration

Configuring the HTTP server allow list (whitelist) on VCS Control
Jabber client endpoints may need to access additional web services inside the enterprise. This requires an
"allow list" of servers to be configured to which the VCS will grant access for HTTP traffic originating from
outside the enterprise.
The features and services that may be required, and would need whitelisting, include:
Cisco VCS Administrator Guide (X8.1.1)
VCS Control
Do not check credentials
Enter the FQDN of the VCS
Expressway.
Note that if you use an IP address
(not recommended), that address
must be present in the VCS
Expressway server certificate.
Enter the FQDNs of additional peers
if it is a cluster of VCS Expressways.
Communications.
Configuring mobile and remote access on VCS
VCS Expressway
Do not check credentials
Not applicable
Not applicable
Page 75 of 507