Cisco TelePresence Administrator's Manual page 408

Reference material
ID Title
20018 Invalid clustering
configuration
20019 Cluster name
not configured
25001 Restart required
25002 Date and time
not validated
25003 IP configuration
mismatch
25004 IP configuration
mismatch
25006 Restart required
25007 Restart required
25008 Restart required
25009 Restart required
25010 Restart required
25011 Restart required
25013 IP configuration
mismatch
25014 Configuration
warning
25015 Restart required
Cisco VCS Administrator Guide (X8.1.1)
Description
H.323 mode must be turned On -
clustering uses H.323
communications between peers
If FindMe or clustering are in use a
cluster name must be defined.
Network configuration has been
changed, however a restart is
required for this to take effect
The system is unable to obtain the
correct time and date from an NTP
server
IP protocol is set to both IPv4 and
IPv6, but the system does not have
any IPv4 addresses defined
IP protocol is set to both IPv4 and
IPv6, but the system does not have
an IPv4 gateway defined
Advanced Networking option key
has been changed, however a
restart is required for this to take
effect
QoS settings have been changed,
however a restart is required for this
to take effect
Port configuration has been
changed, however a restart is
required for this to take effect
Ethernet configuration has been
changed, however a restart is
required for this to take effect
IP configuration has been changed,
however a restart is required for this
to take effect
HTTPS service has been changed,
however a restart is required for this
to take effect
IP protocol is set to both IPv4 and
IPv6, but the system does not have
an IPv6 gateway defined
IP protocol is set to both IPv4 and
IPv6, but the VCS does not have
any IPv6 addresses defined
SSH service has been changed,
however a restart is required for this
to take effect
Solution
Configure H.323 mode
Configure the cluster name
Restart the system
Check the time configuration
Configure IP settings
Configure IP settings
Configure your required LAN and
static NAT settings on the IP
and then restart the system.
Restart the system
Restart the system
Restart the system
Restart the system
Restart the system
Configure IP settings
Configure IP settings
Restart the system
Alarms
Severity
Warning
Warning
Warning
Warning
Warning
Warning
Warning
page
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Warning
Page 408 of 507