Cisco TelePresence Administrator's Manual page 416

Reference material
ID Title
40046 FIPS140-2
compliance
restriction
40048 Unified
Communications
configuration
error
40100 Security alert
45001 Failed to load
Call Policy file
45002 Configuration
warning
45003 Configuration
warning
45004 Configuration
conflict
45005 Configuration
conflict
45006 Configuration
warning
45007 Configuration
warning
45008 Configuration
warning
45009 Configuration
warning
45012 Configuration
warning
Cisco VCS Administrator Guide (X8.1.1)
Description
Clustered systems are not FIPS140-
2 compliant
Unified Communications services
are enabled but SIP TLS is disabled
Firewall rules are not synchronized
with network interfaces
<failure details>
Expected default link between the
Default Subzone and the Default
Zone is missing
H.323 and SIP modes are set to Off;
one or both of them should be
enabled
The FindMe mode is set to On or
Remote service but the FindMe
option key has been deleted
H323-SIP Protocol Interworking
mode is set to Registered only but
the H323-SIP Interworking Gateway
option key has been deleted
Expected default link between the
Default Subzone and the Cluster
Subzone is missing
Expected default link between the
Default Subzone and the Traversal
Subzone is missing
Expected default link between the
Traversal Subzone and the Default
Zone is missing
For provisioning to work correctly,
authentication policy must be
enabled on the Default Zone and
any other relevant zone that
receives provisioning requests
For Presence services to work
correctly, authentication policy must
be enabled on the Default Subzone
and any other relevant subzone;
authentication must also be enabled
on the Default Zone if the endpoints
are not registered
Solution
Disband the cluster
Ensure that SIP TLS mode is set to
'On' on SIP configuration page
Restart the system; if the problem
persists, contact your Cisco
representative
Configure Call Policy
Configure default links
Configure H.323 and/or SIP
Reconfigure FindMe mode
reinstall the option key
Reconfigure Interworking mode
reinstall the option key
Configure default links
Configure default links
Configure default links
Set authentication policy to either
'Check credentials' or 'Treat as
authenticated' for each relevant zone
Set authentication policy to either
"Check credentials" or "Treat as
authenticated" for the Default
Subzone and each relevant subzone
and zone
Alarms
Severity
Warning
Warning
Warning
Warning
Warning
modes Warning
or Warning
or Warning
Warning
Warning
Warning
Warning
Warning
Page 416 of 507