Electrical Connections - Zodiac PW-5m Instructions For Installation And Use Manual

Respect the direction of the hydraulic connection (see § "Dimensions" in
the appendix).

1.3.4 Electrical connections

Prior to any operation, check that:
- The voltage on the identifi cation plate of the appliance corresponds to the
main voltage available on site.
- the socket and the power supplied are adapted to the power requirements
of the heat pump, and that they are grounded,
- the electrical plug is adapted to the socket available.
• connect the power cord supplied with the appliance to a 16A socket com-
plying with the standards and regulations in force in the country where it
is installed,
• extension cords and adapters must not be used.
• If the power supply cable is not long enough, contact a qualifi ed technician.
Risk of electrical shock inside the device.
Only a fully qualifi ed and approved technician should perform cabling con-
nections inside the appliance.
If the power cable is damaged it must be replaced by a qualifi ed technician.
6
Without by-pass



With by-pass
VB
(recommended)
0,2m*
0,8m*
0,3m*
3m*
* Minimum distance

fi lter

water treatment

by-pass
VS
VE