Checks To Perform After Operating The Appliance; Winterizing - Zodiac PW-5m Instructions For Installation And Use Manual

• To turn on the appliance: press for 2 seconds on
• To set the desired temperature ("requested temperature") : when the heat
pump is operating, press on
It is possible to read the water temperature:
when water is fl owing through the heat pump, press on
temperature
It is possible to lock the keyboard:
• lock the keyboard: press on
• unlock the keyboard: press on

2.4 Checks to perform after operating the appliance

After following the steps for running the heat pump, temporarily cut the wa-
ter circulation to check that the heat pump stops operating:
the water fl ow diode should fl ash.

2.5 Winterizing

Winterizing is essential due to the risk of the condenser freezing. This situ-
ation is not covered by the warranty.
• switch off the heat pump by pressing the
disconnect the power cable,
• ensure that no water is fl owing through the heat pump,
• drain the water condenser (risk of freezing) by removing the two pool wa-
ter inlet and outlet connections at the back of the heat pump,
• in the case of a full winterizing of the pool: connect the inlet and outlet con-
nections "lightly" without tightening (one turn) in order to avoid foreign
bodies entering into the condenser,
• in the case of winterizing the heat pump alone: do not reconnect the inlet
and outlet connectors, instead place two stops (supplied) on the condenser
water inlet and outlet.
To avoid damaging the appliance with condensation, do not cover it with an
air-tight cover.
8
by default the screen will display the requested temperature,
or
fl ashes for 10 seconds then displays the fi xed requested
will be displayed for 3 seconds then:
will fl ash for 4 seconds then:
:
to set the value,
and simultaneously for 3 seconds:
and simultaneously for 3 seconds:
button for 2 seconds, then
then
:
,
,