Setting/Replacing The Back Tubes; Replacing The Push Handles - Otto Bock Motus Service Manual

Reposition the straps as desired, attach them again with the hook-and-loop fasteners, and cover
with the padding.

4.4.2 Setting/Replacing the Back Tubes

The back tube which is integrated into the rear frame allows for the adjustment of the back height
in increments of 2. cm.
If applicable, loosen and remove the screw connection between the side panel and back tube
(Fig. ). Remove the mounting clamps from the back tube (Fig. 0).
Remove all screws from the rear frame tube including the screw connection of the rear wheel
adapter (Fig. 1) and set the desired back height. For assembly, please proceed in reverse
order.
When making adjustments, ensure that the back tube is slid at least 7 mm into the
INfORMATION
rear frame tube. Make sure to firmly retighten all screws and nuts after making adjustments!

4.4.3 Replacing the Push Handles

Loosen and remove the two screws at the upper back tube (Fig. 2). Pull the push handles up
out of the tube.
Replace the push handles. For assembly, please proceed in reverse order.
7

8
0
21