Changing The Rear Wheel Adapter Position In The Frame; Changing The Position Of The Fitting In The Adapter - Otto Bock Motus Service Manual

4.7.4 Changing the Rear Wheel Adapter Position in the frame

Loosen all four screw connections (Fig. 1, see arrows) and remove the screws. Move the adapter
to the desired position and firmly retighten the screws.
Additional rear wheel positions can be obtained by turning the rear wheel adapter by 180 de-
grees.
When the rear wheel position is changed, the angle of the caster axle in relation to
INfORMATION
the ground also changes. Ensure that this angle is always approx. 90° wide (see Section .6.1).
The wheel lock must be re-adjusted as well (see Section .8.1).
Make sure to firmly retighten all screws and nuts after making adjustments. The proper
INfORMATION
torque for the screw connection of the rear wheel adapter is 8 Nm. The proper torque for the
screw connection of the fitting is 50 Nm.

4.7.5 Changing the Position of the fitting in the Adapter

To set the centre of gravity, the position of the fitting in the rear wheel adapter can be adjusted
horizontally.
Loosen the screw connection of the fitting (Fig. 2) and remove the fitting. Move the fitting to the
desired position in the rear wheel adapter and firmly retighten the screws.
0
1