Using Surround Modes (Remote Control) - JVC RX-E100RSL Instructions Manual

It will be convenient for you to use the remote control
for DSP operations, since you can adjust them from
your listening point, and use the test signal.
• When using the buttons on the front panel, see pages 37
to 39.
DVD STB
DVD STB
ANALOG/DIGITAL TAPE
INPUT
SOUND BASS+
1
BASS–
TEST
TEST
4
BASS BOOST TREBLE+
7
EFFECT
TREBLE–
10
RETURN
EON SELECT
DISPLAY MODE
DVD MENU
PTY(
ENTER
DSP
MODE
TV VOL CHANNEL
TV/VIDEO DIMMER
/REW PLAY
DOWN TUNING
REC
RM-SRXE100R
HOME CINEMA CONTROL CENTER
Before you start, remember...
• Make sure that you have set the speaker information correctly
(see page 15).
• You cannot adjust the center speaker output level when you have
set "CTR SP" to "NO."
• You cannot adjust the rear speaker output levels when you have set
"REAR SP" to "NO."
• Remember not to change the speaker setting while using any DSP
mode; otherwise, it may be canceled when you deactivate the
speakers required for the DSP mode.
AUDIO
VCR TV
SLEEP TV DIRECT
VCR TV
FM AM
CENTER
2 3
REAR-L
5 6
REAR-R
8 9
SUBWOOFER
0
+10
FM MODE 100+
RDS
DVD
MENU
EON
PTY9
SURROUND
SURROUND
ON/OFF
ON/OFF
PTY SEARCH
VOLUME
VCR MUTING
CONTROL
FF/
UP
STOP PAUSE
REMOTE CONTROL

Using Surround Modes (Remote Control)

Surround mode cannot be used with another DSP mode. Once
Surround mode is activated, the other DSP mode in use will be
canceled.
• You have to make this adjustment for each source.
1
Select and play software encoded with Dolby
Surround, Dolby Digital, or DTS Digital
Surround.
If "AUTO SR (Auto Surround)" is set to "ON"
Playing a digital source automatically activates an appropriate
Surround mode. (See pages 18 and 19.)
2
Press SURROUND ON/OFF to activate an
appropriate Surround mode — Pro Logic, Dolby
Digital, or DTS Digital Surround.
• Each time you press the button, Surround mode turns on and
off alternately.
SURROUND
ON/OFF
AUTO
AUTO
Ex.: When Dolby Digital is activated
Note:
When playing back an analogue source, "SURROUND ON" will
not appear, and "PRO LOGIC" appears as soon as you press
SURROUND ON/OFF. (The PRO LOGIC indicator also lights up
on the display.)
3
Press TEST to check the speaker output balance.
TEST
O LOGIC
P
TL AUTO
UT ATT
"TEST L" starts flashing on the display, and a test tone comes
out of the speakers in the following order:
(Left front speaker)
(Center speaker)
(Left rear speaker)
Notes:
• You can adjust the speaker output levels without outputting the
test tone.
• No test tone comes out of the center speaker when "CTR SP"
is set to "NO."
• No test tone comes out of the rear speakers when "REAR SP"
is set to "NO."
TO BE CONTINUED ON THE NEXT PAGE
VOL
Then
VOL
VOL
(Right front speaker)
(Right rear speaker)
33