JVC RX-E100RSL Instructions Manual page 19

Basic Settings
STANDBY
STANDBY/ON
D I G I T A L
S U R R O U N D
SETTING
Delay Time — CTR DL, REAR DL
Adjust the delay time of the sounds from the center speaker and
from the rear speakers, comparing to that of the sound from the front
speakers. If the distance to the center speaker and/or the rear
speakers from your listening point is almost the same as that to the
front speakers, select 0 msec.
• 1 msec increase (or decrease) in delay time corresponds to 11
inch (30 cm) increase (or decrease) in distance.
Left front
speaker
Center speaker
Left rear
speaker
Ex.: In this case, set the center delay to "1 mS" and the
rear delay to "2 mS."
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
16
CONTROL
5/∞/3/2
Display
RX-E100R
TV DIRECT
DVD STB
ANALOG L C R PRO LOGIC
CONTROL
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD DVD STB
D I G I T A L
Right front
speaker
3.0 m
2.7 m
2.4 m
2.1 m
Right rear
speaker
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
SLEEP RDS EON TA HEWS INFO TUNED ST AUTO MUTING
MH
Z
KH
Z INPUT SURROUND
VOL
ANALOG/DIGITAL
INPUT ATT
VCR TV TAPE FM/AM
2
Press CONTROL ∞ (or 5) repeatedly until
"CTR DL (Center Delay)" or "REAR DL (Rear
Delay)" (with the current setting)
display.
CONTROL
13 /
16
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
CTR DL (Center Delay) : To adjust the center delay time
REAR DL (Rear Delay) : To adjust the rear delay time
* "0 mS" is the initial setting for the center delay time and
"5 mS" for the rear delay time. If you have already changed
the setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to select the delay
time.
• Each time you press the button, the delay time changes by
1 msec (mS).
CONTROL
PRO LOGIC
ANALOG L C R
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
Ex.: When adjusting the center delay
4 2
Repeat steps
time.
DSP
ON/OFF MODE
MASTER VOLUME
appears on the
*
(from 0 msec to 5 msec).
(from 0 msec to 15 msec).
3
and to adjust the other delay
VOL
VOL