Table of Contents
Advertisement
Operating external components with the remote control
The buttons described below are used on pages 14 and
15.
NOTE
• Manufacturers' codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
Operating the TV
7 To set the manufacturer's code
You can operate a JVC TV without setting the manufacturer's code.
1
Slide the remote control mode selector
to TV.
2
Press and hold F TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
For a Toshiba TV:
Remote control
mode selector
(play button)
5
Release F TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Number
Before using the remote control to operate a TV;
buttons
• Set the remote control mode selector to TV.
The following buttons are available:
F TV:
TV VOL +/–:
TV/VIDEO:
CHANNEL +/–:
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
Operating the DBS tuner
or CATV converter
7 To set the manufacturer's code
1
Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold F VCR/DBS.
Keep the button pressed until step 5 is finished.
4
Press ENTER.
Press 1, then 0.
Press 0, then 8.
Manufacturer
Code
JVC
01
Hitachi
10
Magnavox
02
Mitsubishi
03
Panasonic
04, 11
RCA
05
Turns TV on and off.
Adjusts the volume.
Selects the input mode (either TV or
VIDEO).
Changes the channels.
Alternates between the previously selected
channel and the current channel.
Manufacturer
Code
Samsung
12
Sharp
06
Sony
07
Toshiba
08
Zenith
09
Continued on next page
14
Advertisement
Table of Contents
