Table of Contents
Advertisement
Connections
Connecting the power cord
Before plugging the center unit and powered sub-woofer into an AC
outlets, make sure that all connections have been made.
Plug the power cord into an AC outlet.
The red STANDBY lamp on the center unit lights when the power
cord is plugged in.
Keep the power cord away from the connecting cables and the antenna
cable. The power cord may cause noise or screen interference.
We recommend that you use a coaxial cable to connect the FM outdoor
antenna, since it is well-shielded against interference.
Center unit
AC power cord
Connect to
AC outlet.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord.
When unplugging the cord, always grasp the plug so as not to
damage the cord.
Notes:
• The preset settings such as preset channel and sound adjustment
may be erased in a few days in the following cases:
- When you unplug the power cord.
- When a power failure occurs.
• The speakers will not produce any sound if the powered sub woofer
power cord is removed from the AC outlet while the center unit is
turned on.
In this case power will not come on even when the powered sub-
woofer power cord is plugged in the AC outlet.
Press
on the center unit, or
to turn power on. This will turn the powered sub-woofer on and
sound will be emitted from the speakers.
10
Power sub woofer
AUDIO on the remote control
Putting batteries in the remote control
Before using the remote control, put two supplied batteries first.
When using the remote control, aim the remote control directly at
the remote sensor on the center unit.
Primary remote control
Secondary remote control
1.
On the back of the remote control, remove the
battery cover.
2.
Insert batteries. Make sure to match the polarity:
(+) to (–).
3.
Replace the cover.
• If the range or effectiveness of the remote control decreases,
replace the batteries. Use two R6P (SUM-3)/AA (15F) type dry-
cell batteries.
CAUTIONS:
Follow these precautions to avoid leaking or cracking cells:
• Place batteries in the remote control so they match the polarity:
(+) to (–).
• Use the correct type of batteries. Batteries that look similar may
differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
Light up the primary remote control buttons ————
The buttons on the primary remote control may be lit for a few
seconds for use in the dark.
Press LIGHT to illuminate
the buttons in red for a few
seconds.
Advertisement
Table of Contents
