JVC RX-E100RSL Instructions Manual page 17

Basic Settings
STANDBY
STANDBY/ON
D I G I T A L
S U R R O U N D
SETTING
DGTL AUTO : Select this for the digital input mode. The unit
automatically detects the incoming signal
format. (The DGTL AUTO indicator lights up
on the display, then the digital signal indicator
for the detected signals lights up.)
ANALOGUE : Select this for the analogue input mode. (Initial
setting when shipped from the factory.)
If the following symptoms occur while playing Dolby Digital or
DTS Digital Surround software with "DGTL AUTO" selected,
follow the procedure below.
• Sound does not come out at the beginning of playback.
• Noise comes out while searching or skipping chapters or tracks.
1
Press one of the source selecting buttons (DVD, STB, or TV) for
which you want to change the input mode.
DVD DVD STB
2
Press INPUT ANALOG/DIGITAL (or
ANALOG/DIGITAL INPUT) to select the digital input mode
(DGTL AUTO).
INPUT
ANALOG/DIGITAL
INPUT ATT
3
Press CONTROL 3 (or 2) to select "DGTL
D.D." or "DGTL DTS" while "DGTL AUTO"
still remains on the display.
• Each time you press the button, the digital input mode changes
as follows:
When "DGTL D.D." or "DGTL DTS" is
selected, "AUTO" goes off.
CONTROL
L C R
SUBWFR LFE
DOLBY D DGTL AUTO
LS RS
14
CONTROL
5/∞/3/2
Display
RX-E100R
TV DIRECT
DVD STB
ANALOG L C R PRO LOGIC
CONTROL
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD
DVD STB
D I G I T A L
Source selecting buttons
(DVD, STB, TV)
VCR TV
Remote
NOT
Source indicators
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
SLEEP RDS EON TA HEWS INFO TUNED ST AUTO MUTING
MH
Z
KH
Z SURROUND
INPUT
VOL
ANALOG/DIGITAL ON/OFF
INPUT ATT
VCR TV TAPE FM/AM
INPUT
ANALOG/DIGITAL
• To play back software encoded with Dolby Digital, select
"DGTL D.D."
• To play back software encoded with DTS Digital Surround,
select "DGTL DTS."
Note:
When you turn off the power or select another source, "DGTL DTS"
and "DGTL D.D." are canceled and the digital input mode is
automatically reset to "DGTL AUTO."
The following are the analogue/digital signal indicators on the
display to indicate what type of the signal comes into the unit.
ANALOGUE : Lights when the analogue input is selected.
LPCM
: Lights when Linear PCM signals come in.
DOLBY D
: • Lights when Dolby Digital signals come in.
• Flashes when "DGTL D.D." is selected for
software not encoded with Dolby Digital.
DTS : • Lights when DTS Digital Surround signals
come in.
• Flashes when "DGTL DTS" is selected for
software not encoded with DTS Digital
Surround.
Note:
When "DGTL AUTO" cannot recognize the incoming signals, no digital
signal indicators light up on the display.
MU
MH
KH
VO
DSP
MODE
MASTER VOLUME