Using Theatre Surround (Front Panel) - JVC RX-E100RSL Instructions Manual

Creating Realistic Sound Fields
STANDBY
STANDBY/ON
D I G I T A L
S U R R O U N D
CENTER : To adjust the center speaker output level
(from –10 to +10).
REAR L : To adjust the left rear speaker output level
(from –10 to +10).
REAR R : To adjust the right rear speaker output level
(from –10 to +10).
* "0" is the initial setting for these speaker output levels.
If you have already changed the setting, another setting will be
shown.
5
Press CONTROL 3 (or 2) to adjust the speaker
output level.
• Make adjustments so that the sound level of the selected
speaker is set at the same level as that of the front speakers.
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DGTL AUTO
DOLBY D
LS S RS
DTS INPUT ATT
Ex.: When adjusting the center speaker output level
6 4 5
Repeat steps and
levels.
To cancel Surround Mode
Press SURROUND ON/OFF again so that "STEREO" appears on
the display.
• If Surround mode is canceled while playing back multichannel
digital software, all channel signals are mixed and output through
the front speakers (and subwoofer if you have connected a
subwoofer and set the subwoofer setting correctly – "YES").
38
CONTROL
5/∞/3/2
Display
RX-E100R
TV DIRECT
DVD STB
ANALOG L C R PRO LOGIC
CONTROL
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD DVD STB
D I G I T A L
ADJUST
VOL
to adjust the other speaker
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
SLEEP RDS EON TA HEWS INFO TUNED ST AUTO MUTING
MH
Z
KH
Z INPUT SURROUND
VOL
ANALOG/DIGITAL ON/OFF
INPUT ATT
VCR TV TAPE FM/AM

Using Theatre Surround (Front Panel)

Theatre Surround cannot be used with another DSP mode. Once
Theatre Surround is activated, the other DSP mode in use will be
canceled.
When using the buttons on the front panel, no test tone is available.
Make adjustments while listening to the sound of the source played
back.
• You have to make this adjustment for each source.
• You cannot use Theater Surround if no rear speakers are
connected.
1
Select and play software encoded with Dolby
Surround.
2
Press DSP MODE repeatedly until "THEATRE"
appears on the display.
The PRO LOGIC and DSP indicators light up on the display.
DSP
MODE
ANALOG
3
Press ADJUST.
The CONTROL buttons now work for sound
ADJUST
adjustments.
4
Press CONTROL ∞ (or 5) repeatedly until one
of the following indications (with the current
setting) appears.
*
CONTROL
ANALOG PRO LOGIC
L C R
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
DSP
MODE
MASTER VOLUME
DSP
MODE
L R PRO LOGIC
DSP
SUBWFR
VOL