Basic Settings; Setting The Digital Input Terminals; Selecting The Analogue Or Digital Input Mode - JVC RX-E100RSL Instructions Manual

Basic Settings

STANDBY
STANDBY/ON
D I G I T A L
S U R R O U N D
SETTING
Setting the Digital Input
Terminals
When you use the digital input terminals, register what components
are connected to which terminals (DIGITAL IN 1/2) so that the
correct source name will appear when you select the digital source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
"DGT (Digital)" (with the current setting)
appears on the display.
CONTROL
* "1DVD2STB" is the initial setting. If you have already
changed setting, another combination will be shown.
3
Press CONTROL 3 (or 2) to select the
appropriate digital terminal setting.
• Each time you press the button, the display changes to show
the following:
CONTROL
ANALOG PRO LOGIC
L C R
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
(back to the begining)
CONTROL
5/∞/3/2
Display
RX-E100R
TV DIRECT
DVD STB
ANALOG L C R PRO LOGIC
CONTROL
DSP
LPCM
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD DVD STB
D I G I T A L
Source selecting buttons
(DVD, STB, TV)
Remote
NOT
*
VOL
VOL
Source indicators
HOME CINEMA CONTROL CENTER
VCR TV TAPE FM/AM
SLEEP RDS EON TA HEWS INFO TUNED ST AUTO MUTING
MH
Z
KH
Z SURROUND
INPUT
VOL
ANALOG/DIGITAL ON/OFF
INPUT ATT
VCR TV TAPE FM/AM
INPUT
ANALOG/DIGITAL
Note:
When shipped from the factory, the DIGITAL IN terminals have been
set for use with the following components.
• DIGITAL 1 (coaxial): For DVD player
• DIGITAL 2 (optical): For STB

Selecting the Analogue or Digital Input Mode

When you have connected digital source components using both the
analogue connection and the digital connection methods (see page
7), you need to select the input mode correctly.
1
Press one of the source selecting buttons (DVD,
STB, or TV) for which you want to change the
*
input mode.
DVD DVD
Note:
* Among the sources listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See "Setting the Digital Input Terminals" .)
2
Press INPUT ANALOG/DIGITAL (or
ANALOG/DIGITAL INPUT on the remote
control) to select the analogue or digital input
mode.
• Each time you press the button, the input mode alternates
between the analogue input (ANALOGUE) and the digital
input (DGTL AUTO).
INPUT
ANALOG/DIGITAL
DOLBY D
INPUT ATT
TO BE CONTINUED TO THE NEXT PAGE
DSP
MODE
MASTER VOLUME
STB VCR TV
L C R
SUBWFR LFE
DGTL AUTO
LS RS
13