Selecting The Fm Reception Mode - JVC RX-E100RSL Instructions Manual

To tune in a preset station
1
Press FM/AM to select the band.
The last received station of the selected band is tuned in, and the
CONTROL buttons now work for tuner operations.
FM/AM
Ex.: When selecting the FM band
2
Press CONTROL ∞ (or 5) repeatedly until
"< PRESET >" appears on the display.
CONTROL
Preset channel number appears.
3
Press CONTROL 3 or 2 to select a preset
channel number you want.
CONTROL
• Pressing (or holding) CONTROL 3 increases the preset
channel numbers.
• Pressing (or holding) CONTROL 2 decreases the preset
channel numbers.
When using the remote control
1 Press FM or AM.
The last received station of the selected band is tuned in, and the
10 keys now work for tuner operations.
2 Press the 10 keys to select a preset channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 30, press +10, +10, then 10.
TUNED ST AUTO MUTING
MH
Z
VOL
TUNED ST AUTO MUTING
VOL
Then
TUNED ST AUTO MUTING
MH
Z
VOL
TUNED ST AUTO MUTING
MH
Z
VOL

Selecting the FM Reception Mode

When an FM stereo broadcast is hard to receive or noisy, you can
change the FM reception mode while receiving an FM broadcast.
• You can store the FM reception mode for each preset station.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
While listening to an FM station, press
CONTROL ∞ (or 5) repeatedly until
"< FM MODE >" appears on the display.
CONTROL
2
Press CONTROL 3 (or 2) to select "MONO."
• Each time you press the button, the FM reception mode
alternates between "AUTO MUTING" and "MONO."
CONTROL
ANALOG
L R
* "AUTO MUTING" is the initial setting.
MONO
: Select this to improve the reception (but stereo
effect will be lost).
In this mode, you will hear noise while tuning into
the stations. The AUTO MUTING indicator goes
off from the display. (The ST indicator also goes
off.)
AUTO MUTING : Normally select this. When a program is
broadcasted in stereo, you will hear stereo sound;
when in monaural, you will hear monaural sounds.
This mode is also useful to suppress static noise
between stations. The AUTO MUTING indicator
lights up on the display.
To restore the stereo effect
Repeat step 1, then select "AUTO MUTING" in step 2.
Remote
NOT
TUNED ST AUTO MUTING
MH
Z
VOL
TUNED
MH
Z
VOL
25