Refueling - SCAN DSA 4 Instructions For Use Manual

5.3 Refueling:

To refuel the fireplace, first move the air intake control to full open, let the fire "liven-up" for
about one minute. Open the fuel door about ½" (1.5 cm) and hold in this position until the
fireplace is drafting well. Open the fuel door and add wood. If the fire or coal bed is almost
depleted and a full load of wood is added, it may be necessary to adjust the air intake control
wide open to reestablish a lively fire. The use of start up air should only be used for a short
period of time. Note: After refueling, when the wood is burning at a brisk rate, reset the air
intake control to the desired position by moving the air intake control handle all the way to
closed and then back to the desired setting.
Page 14