Important Safety Notice; Prevent Creosote Fires; Prevent Over Firing - SCAN DSA 4 Instructions For Use Manual

Congratulations on your new SCAN DSA wood burning fireplace. We are confident that you will
enjoy your new SCAN DSA fireplace, especially if you follow the instructions and advice given
below.
SCAN DSA fireplaces have a number plate. In case of complaints we request that you have the
registration number.
In the SCAN DSA fireplace you will find a service box containing the following items:
1 stove mitten
1 handle to operate the door
1 set of fittings for the flue collar
1 set of screws and hexagon spanners
1 bag of fire starters for the first lightning
The SCAN DSA fireplaces have been tested by OMNI-Test Laboratories, Inc. of
Beaverton, Oregon, and are listed by OMNI to UL 1482, ULC S628 and EPA certified.
Please: read the entire manual before installing or operation your new fireplace.

1. IMPORTANT SAFETY NOTICE

The SCAN DSA wood-burning fireplace is a closed fireplace.
Protection against a fire hazard is of primary importance when installing a wood-burning
fireplace. If utilizing an older chimney, it must be inspected for adequate serviceability. Refer to
the heading: Chimney Installation (page 12).
Minimum listed clearances to combustible surfaces and materials must be maintained,
including; furniture, drapers, clothing, wood, papers, etc.

1.1 Prevent Creosote Fires:

Both the chimney and chimney connector should be inspected for creosote deposits at least
twice monthly during the heating season. Remove all buildups as necessary. This fireplace is
approved for burning dry seasoned natural wood only. Using green or inadequately seasoned
wood can greatly increase creosote buildup.

1.2 Prevent Over Firing:

Do not over-fire! Over-firing the fireplace can cause a house fire. If the fireplace glows, you are
over-firing. Damage caused from over firing is not covered by the manufactures limited
warranty.
Page 3