628 & 698 Models
Fig 16.
Draw out inlet end of water pipe tubing from
back of machine, leaving attached at inlet valve end.
Fig 17.
Carefully rotate push fit elbow half a full turn
clockwise and re-route water pipe tubing around right
hand side of tank and down and out of rear of machine.
Fig18.
Connect the plastic plug onto the new circuit board
already fitted to the Tap Cover. Refit the Tap Cover by
locating the top and right side lugs first followed by
squeezing
the cover to locate the left side lug.
Refit the Top Cover to the cooler and check the electrical
operation.
All LEDs should light.
IF TESTING PRIOR TO INSTALLATION, ONLY TEST RUN COOLER DRY FOR A FEW SECONDS.
69