Advertisement
628 & 698 Models
Sanitisation & Cleaning
1. Please make sure that the machine has been disconnected from the electrical supply before any cleaning
commences.
2. The lid of the machine should be removed exposing the inside of the water tank. Now press both the cold tap and
the ambient tap to drain all the water from the reservoir until no water can be seen. Remove the baffle plate found
in the centre of the tank passing it around the float valve to remove it completely. At this stage it is possible to see
whether any water has been left in the base of the tank. A hundred miliilitres of sanitising fluid can now be tipped
into the reservoir.
3. The water can be turned on again briefly to half fill the reservoir with sanitising fluid. The upper half of the
reservoir should be cleaned utilising sanitisation wipes supplied by Azure. Whilst the sanitisation fluid is having its
effect, please clean the external casing with Azure sanitisation wipes. Once the sanitisation fluid has been left for a
satisfactory period of time, please flush the water cooler through at least once by turning the water back on. When
this has been completed, the machine can be reassembled and your sanitisation is complete. Please now switch
the power back on. If you have any question regarding sanitisation please do not hesitate to ring Azure Head Office
on 0845 4 50 30 90.
13
Hot & cold switches
Inlet
Top Cover
Baffle Pipe
Float Valve
Indicator Panel
Taps
Drip Tray
Advertisement
