Advertisement
628 & 698 Models
CW628
Installation and Operational Guide
IMPORTANT - the guide must be read before attempting to connect the machine.
Introduction
Congratulations on your wise choice of water cooler. Your Borg & Overström water cooler will provide you with a
continuous supply of water 24 hours a day. To ensure that his product will always perform as it truly should, the
user should initially read this manual thoroughly and follow all the instructions before operation of the unit
commences.
Installation
The water connection to the Borg & Overström water cooler is via a 1/4" supply. The connection can either be made
utilising the bulk head connector found at the rear of the machine or by connecting an in-line straight connector
direct to the pipe inside the rear of the machine. It is advisable that in any case an in-line isolation tap should be
installed on the supply just behind the machine in case of emergency.
Operation Method
1. Having connected the water supply to the rear of the machine, the water supply should be turned on and you will
hear the reservoir within the machine start to fill. Once this has stopped filling, the entire tank should then be
drained and allowed to refill before operation of the machine commences. If in any doubt at this stage please add
some sanitisation fluid to your initial tank of water so as to flush the machine before use. Once the machine has
refilled with water the machine can be connected to the mains supply and switched on.The switch at the rear of the
machine then needs to be turned on before operation can commence.
NB. If your water cooler has a hot water facility please allow time for the hot tank to fill up before turning on. To
draw water into the hot tank, the hot tap must be held open until water starts to dispense.
2. Both LEDs on the display panel should now be showing. After initial chilling operation has been completed the
chilling lens will go off, which is the bottom of the two lenses showing.
Machine Positioning
1. It is important that at least 10cm is left between the back of the machine and the surface against which it is
placed. This is to ensure that the machine does not in any way overheat.
2. The machine must be kept away from any direct sunlight.
3. It is important that the machine is connected to an RCD connected supply making doubly sure that the voltage
supply is compatible with the machine.
12
Advertisement
