Advertisement

User Guide
B3

Dispense Options

Chilled
Ambient
Contents
Functions & Controls
04
NOTE: This booklet to be left with
appliance following installation.
GB
Borg & Overström
GB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Borg & Overstrom B3

  • Page 1 User Guide Dispense Options Chilled Ambient Contents Component/Feature Overview Operation Functions & Controls General Safety CO2 Bottle Installation NOTE: This booklet to be left with Borg & Overström appliance following installation.
  • Page 2 Component/ Feature Overview B3 - Major Components Cup Dispenser Control Panel Drip Tray Level Sensor Alarm Waste Tank...
  • Page 3 Hot Switch Sparkling/Chilled Switch Power Socket Drain Port Water Inlet...
  • Page 4 Operation C O L D Connect and turn on the water All hot & non sparkling cold On sparkling models turn on supply. Then connect the tanks must be purged of air the carbonation switch on the by holding the corresponding back of the unit.
  • Page 5 Functions & Controls Controls Chilled Sparkling Water Water Water Chilled LED Button Button Button Hot LED Sparkling LED borg&overström Ambient Water Button Basic Settings Cold Thermostat Factory set to: NB: Turn clockwise to decrease water temperature The temperature of cold water can be set from 4c to 11c.
  • Page 6 General Safety • Leave a space no less than 15cm between the wall and dispenser. • Keep the machine away from sunlight, heat and moisture. 15cm Basic Troubleshooting Problem/Report Possible Cause Suggested Action No Water Dispensing Water supply turned off. Check that power supply, and all taps/ valves/ filters on the incoming water supply are fitted and are turned on.
  • Page 7 CO2 Bottle Installation - Sparkling Versions Only C O L D Attach the regulator to the Connect the assembled CO2 After completing the water disposable CO2 bottle, bottle and regulator to the installation, turn on the ensuring the regulator is machine using 1/4 inch pipe.
  • Page 8 +44 1362 695 006 Telephone © Copyright Borg & Overström. +44 (0)1362 695 006 This guide is printed by Borg & Overström and Email shall not be reproduced or copied in anyway. sales@borgandoverstrom.com Ref: 838020 borgandoverstrom.com Version: B3.2.UG.v06082018...

Table of Contents