Table of Contents
Advertisement
Getting started
Console installation
3.
Snap the kickstand into the desired grooves until it locks into place.
4.
Install the telephone lines. Plug one end of the telephone line into the
telephone jack at the back of the console. Plug the other end of the
telephone line into the telephone wall jack. If you subscribe to high-speed
Internet service (DSL - digital subscriber line) through your telephone
lines, you must install a DSL filter between the telephone line cord and
telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for
more information about DSL filters.
5.
Make sure your router is connected to the Ethernet network. Plug one
end of the Ethernet cable into the Ethernet jack (
console, and plug the other end into the router.
6.
Plug the power adapter into an electrical outlet not controlled by a
wall switch.
MS2015 Engraving:
MS2085 Engraving:
8
Use only
Supplied
Adapter
) at the back of the
Use only
Supplied
Adapter
5.1
L4
L3/4
L2
Advertisement
Table of Contents
