CYLINDER HEAD/CYLINDER/PISTON
Fitting the cylinder
- Position the piston ring gap as follows:
A. Top compression ring gap.
B. Compression ring gap.
C. Upper oil control ring gap.
D. Lower oil control ring gap.
- Install the cylinder base gasket and the
2 guiding pillars on the crankcase.
- When refitting the cylinder, we recommend
locking the piston using the fork part
number 756575 in order to facilitate
assembly.
- Fit the cylinder over the piston by
compressing the piston rings by hand.
Lubricate the cylinder.
- Fit the chain and the chain guide tensioner
into the timing chain tunnel.
- Fit the chain pad (1).
- Fit the 2 guiding pillars (2) and the metal
gasket on the cylinder (3).
38
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
B
756575
2
A
D
C
3
1