CRANKCASE
Removal of the crankshaft
- Remove the primary drive.
- Remove the overrunning clutch.
- Remove the cylinder and the piston.
- Remove the starter motor (2 screw).
Tightening torque: 10 Nm.
- Remove the drive gear from the oil
pump (1).
- Remove the circlip (2).
- Remove the oil pump gear.
- Remove the pin.
- Remove the 2 screws that secure the RH
half casing.
- Remove the RH casing.
- Remove the 2 centring pillars and the paper
gasket.
Reproduction ou traduction, même partielle, interdite sans autorisation écrite de Peugeot Motocycles
CRANKCASE
1
2
41