3A – 12IAUTOMATIC TRANSAXLE DRIVE AXLE
5.
Fill the tripot housing with 195 to 215 g (6.9 to 7.6
ounces) of the recommended grease. Repack the
tripot with 195 to 215 g (6.9 to 7.6 ounces) of the
recommended grease.
6.
Install the tripot housing onto the tripot assembly.
7.
Install the tripot joint retaining ring into the tripot
housing.
8.
Install a new large seal retaining clamp. Crimp the
large seal retaining clamp using the seal clamp pli-
ers J–35566.
9.
Crimp the new small seal retaining clamp using the
seal clamp pliers J–35566.
10. Install the drive axle shaft to the vehicle. Refer
to"Drive Axle Assembly" in this section.
DAEWOO V–121 BL4