Daewoo Nubira User Manual page 39

DAEWOO V–121 BL4
WIPERS/WASHER SYSTEMS 9D – 13
4. Pry the wiper arm linkage off the motor drive shaft.
5. Remove the nuts and reposition the engine coolant
reservoir.
6. Disconnect the electrical connector.
7. Remove the bolts and the wiper motor.
Installation Procedure
Notice : Dissimilar metals in direct contact with each other
may corrode rapidly. Make sure to use the correct fasten-
ers to prevent premature corrosion.
1. Install the wiper motor with the bolts.
Tighten
Tighten the wiper motor bolts to 8 NSm (71 lb–in).
2. Connect the electrical connector.
3. Press the wiper arm linkage onto the motor drive
shaft.
4. Install the wiper arm linkage to the motor drive shaft
with the washer and the nut.
Tighten
Tighten the wiper arm linkage nut to 5 NSm (44 lb–in).
5. Install the left side portion of the cowl vent grille.
Refer toSection 9R, Body Front End.
6. Connect the negative battery cable.