Camshafts - Daewoo Nubira User Manual

1C – 24IDOHC ENGINE MECHANICAL
57. Connect the coolant temperature sensor connector.
58. Connect the engine coolant temperature sensor
connector.
59. Connect the idle air control valve connector.
60. Connect the throttle position sensor connector.
61. Install the evaporative emission canister purge so-
lenoid bracket bolt.
Tighten
Tighten the evaporative emission canister purge sole-
noid bracket bolt to 5 NSm (44 lb–in).
62. Connect the EI system ignition coil connector.
63. Connect the pre–converter oxygen sensor connec-
tor.
64. Connect the PCM/ECM ground terminal.
65. Install the fuel pump fuse.
66. Connect the negative battery ground cable.
67. Refill the engine cooling system. Refer to Section
1D, Engine Cooling.

CAMSHAFTS

Removal Procedure
1. Remove the timing belt. Refer to "Timing Belt" in
this section.
2. Disconnect the breather tube at the valve cover.
3. Disconnect the crankcase ventilation tube at the
valve cover.
4. Remove the spark plug cover bolts.
5. Remove the spark plug cover.
6. Disconnect the ignition wires from the spark plugs.
7. Disconnect the camshaft position sensor.
8. Remove the valve cover bolts.
9. Remove the valve cover washers.
10. Remove the valve cover and the valve cover gas-
ket.
DAEWOO V–121 BL4