Daewoo Nubira User Manual page 210

4E – 4IREAR DISC BRAKES
Installation Procedure
1. Measure the minimum shoe lining thickness. Refer
to"Lining Inspection"in this section.
2. Install the brake shoes.
3. Push the piston inward, if needed.
Notice : Do not damage the piston seal when the caliper
is pivoted downward.
4. Pivot the caliper downward and install the lower
bolt.
Tighten
Tighten the lower caliper mounting bolt to 31 NSm (23
lb–ft).
5. Align the match marks that were made before re-
moval and install the rear wheels. Refer toSection
2E, Tires and Wheels.
6. Lower the vehicle.
CALIPER
Removal Procedure
1. Raise and suitably support the vehicle.
2. To preserve wheel balance, mark the position of the
rear wheels relative to the wheel hubs and remove
the wheels. Refer toSection 2E, Tires and Wheels.
3. Remove the brake hose caliper inlet bolt and the
washers.
DAEWOO V–121 BL4