DAEWOO V–121 BL4
REMOTE KEYLESS ENTRY AND ANTI–THEFT SYSTEM 9T – 5
MAINTENANCE AND REPAIR
CONTROL MODULE/RECEIVER
Removal Procedure
1.
2.
3.
4.
Installation Procedure
1.
2.
3.
4.
SIREN
Removal Procedure
1.
ON–VEHICLE SERVICE
Disconnect the negative battery cable.
Remove floor console left side forward trim panel.
Refer to Section 9G, Interior Trim.
Disconnect the control module/receiver electrical
connector.
Slide the control module/receiver toward the rear of
the vehicle and remove it.
Install the control module/receiver by sliding it onto
its bracket.
Connect the control module/receiver electrical con-
nector.
Install the floor console left side forward trim panel.
Refer to Section 9G, Interior Trim.
Connect the negative battery cable.
Remove several screws to boosen the forward half
of the right front wheel well splash shield.