Daewoo Nubira User Manual page 638

Description
Fuel Level Sensor Procedures
4. Using a suitable pair of diagonal cutters, cut
off the two (2) Fuel Level Sensor Terminals
previously released/removed from the sub-
harness connector, then discard those
terminals.
5. Disengage the Fuel Level Sensor wires from
the retaining hook at the top of the Fuel Pump
Module Body, then pull the cut wire ends out
of the fuel pump body through the built-in
tube.
6. Pull the Low Fuel Level Sensor from its
bracket.
7. Using a small flat-blade screwdriver, release
the Low Fuel Level Sensor Bracket from the
Fuel Pump Module Body by prying it in the
direction shown. The bracket will slide
through the retaining rail as you pull it free of
the Fuel Pump Module Body.
Note: Prying in the opposite direction may
cause damage to the lock that retains
the Low Fuel Sensor Bracket.
8. Remove the Fuel Level Sensor by prying it in
the same direction from the same retaining rail
that previously held the Low Fuel Sensor
Bracket.
August, 2001
Remove Terminals
Retaining Hook
Low Fuel Level
Sensor Bracket
Prying Direction
Fuel Level Sensor
Page
4 of 7