4B – 10IMASTER CYLINDER
9.
Lubricate the seal ring and insert the seal into the
cylinder bore. The open side must face outward
until the seal rests on the piston.
10. Install the brake fluid reservoir to the master cylin-
der. Refer to"Brake Fluid Reservoir"in this section.
11. Install the master cylinder assembly. Refer to
the"Master Cylinder Assembly"in this section.
12. Raise and suitably support the vehicle.
13. Bleed the braking system. Refer toSection 4A, Hy-
draulic Brakes or Section 4F, Antilock Brake Sys-
tem.
14. Lower the vehicle.
DAEWOO V–121 BL4