Daewoo Nubira User Manual page 196

SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . .
FASTENER TIGHTENING SPECIFICATIONS
DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LINING INSPECTION
ROTOR INSPECTION
MAINTENANCE AND REPAIR
ON–VEHICLE SERVICE
SHOE AND LINING
Brake Hose Inlet Fitting–to–Caliper Bolt
Caliper–to–Steering Knuckle Mounting Bolts
Retaining Frame–to–Caliper Housing Bolts
Rotor–to–Front Wheel Hub Detent Screw
Splash Shield–to–Steering Knuckle Screws
DIAGNOSIS
LINING INSPECTION
1. Raise and suitably support the vehicle.
2. Remove the front wheels. Refer toSection 2E, Tires
and Wheels.
3. Visually check the linings for minimum thickness
and wear.
4. Measure the thickness.
Important : The minimum thickness of the inner or outer
pad is 9 mm(0.35 inch).
1. Install the brake pads in axle sets only.
2. Install the front wheels. Refer toSection 2E, Tires
and Wheels.
FRONT DISC BRAKES
TABLE OF CONTENTS
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Application
SECTION : 4D
4D–1 CALIPER
. 4D–1
ROTOR
SPLASH SHIELD
4D–1
UNIT REPAIR
4D–1
4D–1
CALIPER OVERHAUL
4D–3
GENERAL DESCRIPTION AND SYSTEM
OPERATION
4D–3
4D–3 DISC BRAKE CALIPER ASSEMBLY
3. Lower the vehicle.
ROTOR INSPECTION
Thickness variation can be checked by measuring the
thickness of the rotor at four or more points around the cir-
cumference of the rotor. All measurements must be made
at the same distance in from the edge of the rotor.
A rotor that varies by more than 0.005 mm (0.0005 inch)
can cause pedal pulsations and/or front end vibration dur-
ing brake applications. A rotor that does not meet these
specifications should be refinished to specifications or re-
placed.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NSm Lb–Ft
40 30
95 70
22–32 16–24
4 –
5 –
4D–4
4D–6
4D–7
4D–9
4D–9
4D–11
. . . . . . . . 4D–11
Lb–In
–
–
–
35
44