Removable Media Device Options; Removing The Removable Media Blanks - HP ProLiant ML370 Generation 5 User Manual

For rack models, install the rack bezel.
12.
Install the access panel (on page 26).
13.
Install hard drives
14.
Do one of the following:
15.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
CAUTION:
all bays are populated with either a component or a blank.

Removable media device options

The server supports the installation of a CD-ROM drive, USB tape drive, or optional diskette drive in the
removable media bay.

Removing the removable media blanks

Power down the server (on page 20).
1.
Unlock the tower bezel.
2.
CAUTION:
all bays are populated with either a component or a blank.
NOTE:
ease of installation. It is not necessary to disconnect and remove the CD-ROM drive from the
server entirely.
("Installing a hot-plug hard
To prevent improper cooling and thermal damage, do not operate the server unless
To prevent improper cooling and thermal damage, do not operate the server unless
HP recommends that you move the CD-ROM drive out of the media cabling area for
drive" on page 51) or hard drive blanks, as needed.
Hardware options installation 55